The point of fatal error problem during installation of windows XP

One time I had to face the computer installation fairly difficult, because it always fails and fails. I did get a couple of ways ranging from booting via CD, boot using USB, even some of the OS with the integration of different drivers in it, but it still can not. The process of moving files to the hard drive always corupt, for some reason when I put on a CD that I have just made, and the CDROM was already several times I change, but still, the result is always failure. Finally I try to boot using USB, when installing on the first step successfully, but the second step finding a fatal error as shown below: 

the cause of the problem

1. appropriate that I described above, check your windows installation CD, if it had been scraped better you create a new installation CD again.
2. Might occur on your computer CDROM devices are already weak, so it can not read the files on the CD perfectly.
3. wipe your computer's CPU, by opening all the hardware that attaches to the motherboard, and of course have to be careful opening and put it back. There is a possibility of dirt on the hardware that is the cause. 
4. And if its installation CD and CDROM you have updated, even clean the CPU you have, but still an error, if you stick 2 CPU RAM memory, the memory test by unplugging one, turn on the computer and if your computer can not boot to bios / does not appear on the screen / remove noise, means that your memory is dead or weak. and you also have to immediately buy a new memory to solve this problem. 

so many of my posts, hopefully useful.
experience is the greatest teacher, and basically you should be able to learn from the mistakes that you can.